Usglobalsat EB-5631RE Uživatelský manuál

2012/7/30 - 1 - GLOBALSAT GPS Engine Board Hardware Data Sheet Product

2012/7/30 - 10 - SOFTWARE COMMAND NMEA Output Command GGA - Global Posit

2012/7/30 - 11 - Note: A valid status is derived from all the paramet

2012/7/30 - 12 - GSA - GNSS DOP and Active Satellites Table B-5 contains

2012/7/30 - 13 - GSV - GNSS Satellites in View Table B-8 contains the va

2012/7/30 - 14 - RMC - Recommended Minimum Specific GNSS Data Note – F

2012/7/30 - 15 - VTG - Course Over Ground and Ground Speed Note – Fiel

2012/7/30 - 16 - ZDA - Time and Date This message is included only wit

2012/7/30 - 17 - NMEA Input Command A). Set Serial Port ID: 100 Set PORT

2012/7/30 - 18 - Format： $PSRF101,<X>,<Y>,<Z>,<ClkO

2012/7/30 - 19 - the parameters will be stored in battery backed SRAM an

2012/7/30 - 2 - Product Description Product Description EB-5631RE GPS mod

2012/7/30 - 20 - Example 1: Query the GGA message with checksum enabled

2012/7/30 - 21 - Example: Start using known position and time. ＄PSRF104,

2012/7/30 - 22 - PCB Layout Recommend Recommended Layout PAD

2012/7/30 - 23 - Recommended Reflow Profile: Pre heating temperature:

2012/7/30 - 24 - Appendix LABEL Artwork A: Brand: GLOBALSAT B: MODULE M

2012/7/30 - 3 - Product Pin Description PIN Number(s) Name Type Descri

2012/7/30 - 4 - <Note> 1. GPIO is 1.8V Level 2. The ON_OFF pin co

2012/7/30 - 5 - DC Electrical characteristics Parameter Symbol Min. Typ.

2012/7/30 - 6 - Environmental Characteristics Parameter Min Typ Max Unit

2012/7/30 - 7 - Application Application Circuit VBATC1010UFRESETGPIO1PP

2012/7/30 - 8 - NOTE: 1. RESET: Low Active, when EB-5631RE is accepted t

2012/7/30 - 9 - OPERATING Description RF_IN This pin receives signal